UPDATED**Nordyne/ No heat in auto-only in vent mode??

Questions about repairs and parts for Nordyne furnaces, air conditioners and heat pumps for manufactured homes including Intertherm, Mac and Miller brands. Click here for Nordyne parts.

Moderators: Greg, Mark

Locked
Ereed2
Posts: 14
Joined: Tue Dec 08, 2009 6:41 pm

Hello Robert! Finally got around to doing this and this still does not work. I removed the yellow wire and plugged in in where the red wire is as you said and I still have no heat and no motor run in Auto-Heat mode?? I am out of ideas, not sure its the motor anymore?
Top
User avatar
Robert
Moderator
Posts: 6413
Joined: Wed Feb 28, 2007 12:07 am
Location: Tennessee

IF there is power to the motor there, it should run if it's ok.



Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
Top
Ereed2
Posts: 14
Joined: Tue Dec 08, 2009 6:41 pm

Robert, I have power there (240VAC) but no motor? I swapped the yellow wire for the red wire at the molex plug at the motor and call for heat and still no blower?
Top
User avatar
Robert
Moderator
Posts: 6413
Joined: Wed Feb 28, 2007 12:07 am
Location: Tennessee

Hi,

IF there is 240vac at the molex plug and through it and motor will not run when you spin the wheel with a call for heat, then the motor is bad.


Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
Top
Locked
  • Similar Topics
    Replies
    Views
    Last post

Return to “Nordyne Service & Repair”