Good morning,
I am replacing an Intertherm with a bad combustion chamber with a Nordyne M1MB 070A BW.
Measurements indicate I need 26" JAck. However, my roof is one of those curved metal roofs, will I need to order that is setup for a pitched roof?
Thanks for your time.
Roof Jack for M1MB
If it is not flat where the roof-jack will be set, then you'll need the pitched roof option.
I would get one with the 26" in the middle of the distances listed to give a little + or - needed.
Thanks,
Robert
I would get one with the 26" in the middle of the distances listed to give a little + or - needed.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Nordyne M1MB clicks 4 times when starting
by olsonlaaa » Thu Aug 24, 2017 10:54 am » in Nordyne Service & Repair - 0 Replies
- 46777 Views
-
Last post by olsonlaaa
Thu Aug 24, 2017 10:54 am
-
-
-
Nordyne model m1mb 070a bw power issue
by Combustibleink » Mon Nov 16, 2020 10:21 am » in Nordyne Service & Repair - 0 Replies
- 114495 Views
-
Last post by Combustibleink
Mon Nov 16, 2020 10:21 am
-
-
-
Questions about steel roof options for arched roof
by Reezer76 » Thu Sep 14, 2017 9:41 pm » in Mobile Home Repair - 2 Replies
- 63897 Views
-
Last post by JD
Sun Sep 17, 2017 4:31 pm
-
-
- 5 Replies
- 102674 Views
-
Last post by JenniferK
Wed Nov 22, 2017 12:52 am
-
- 2 Replies
- 64835 Views
-
Last post by JenniferK
Fri Nov 24, 2017 2:02 am