nordyne B3BM-030K-A cycling for only a second
-
- Posts: 2
- Joined: Mon Sep 27, 2010 12:04 pm
i have an electric furnace that once it gets the house to around 70* and goes off. when it cycles back on it will only run for a second or two and then shut off. it will continue this until you actually turn the heater off at the thermostat or the breaker. the landlord had a guy come out and thought that it was the wall thermostat so he changed it out, but now it is doing it again. it does blow hot air and after turning it off for a while then turning it back on it will run for a while till it shuts off, then it starts the on/off cycle for just a second at a time. little help it what may be causing it would be appreciated.
Most likely a bad sequencer or contactor, whichever it has (not able to look it up right now).
That is what controls the heating element and blower motor.
Thanks,
Robert
That is what controls the heating element and blower motor.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Posts: 2
- Joined: Mon Sep 27, 2010 12:04 pm
so where do i find a manual that shows me where those parts are? have been hunting the net but not finding much. any idea about what those parts might run?
Look on the lower furnace facing for data sticker and get the furnace model number. The number given is an a-coil model number.
Thanks,
Robert
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Intertherm/Nordyne feh-015ha furnace issues blower not working, unit will only turn off at breaker box
by onmypath78 » Sat Mar 16, 2019 12:11 pm » in Nordyne Service & Repair - 0 Replies
- 165359 Views
-
Last post by onmypath78
Sat Mar 16, 2019 12:11 pm
-
-
-
Eb15a elec furnace will only come on if jumpered at themostat
by redcat31 » Wed Jan 31, 2018 6:18 pm » in Service & Repair of Other Brands - 0 Replies
- 22820 Views
-
Last post by redcat31
Sat Feb 03, 2018 1:20 am
-
-
-
Nordyne M1MB clicks 4 times when starting
by olsonlaaa » Thu Aug 24, 2017 10:54 am » in Nordyne Service & Repair - 0 Replies
- 46835 Views
-
Last post by olsonlaaa
Thu Aug 24, 2017 10:54 am
-
-
-
Help with Nordyne electronic board
by swade1991 » Thu Aug 02, 2018 12:13 pm » in Nordyne Service & Repair - 0 Replies
- 32461 Views
-
Last post by swade1991
Thu Aug 02, 2018 12:13 pm
-
-
- 2 Replies
- 25166 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:35 am