I have a two questions that I hope someone will be able to help me with.
I have a Miller Furnace in a single wide mobile home with the bottom of the fuel tank approximately 3 feet below the pump. The current set-up is a 3/8" O.D. one-line system with the fuel line and filter attached to the valve at the bottom of the tank. I want to change the fuel line to come from the top of the tank using a duplex fitting and have purchased a Gar-Ber spin-on fuel filter that I would like to install in the burner cabinet to the left and above the burner.
The first question is with the top of the filter housing about 10 inches above the pump will I be creating problems with trapping air at this filter loop.
The second question is the filter instructions state "All fittings should be flared, 1/2" O.D. tubing." Do I need to change tubing diameter or will the existing work.
Thanks!
Ed
Beckett Model AF-15 Filter Location
Hi Ed,
Since I do not and have not very much done work on oil furnaces, I will leave this here for those with oil furnace knowledge to answer.
Thanks,
Robert
Since I do not and have not very much done work on oil furnaces, I will leave this here for those with oil furnace knowledge to answer.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
- 3 Replies
- 15974 Views
-
Last post by Greg
Sat Dec 22, 2018 10:05 am
-
-
Need advice regarding a heat\AC register location
by JustRayInWi » Mon Aug 24, 2020 8:49 pm » in Mobile Home Repair - 2 Replies
- 16802 Views
-
Last post by JustRayInWi
Thu Aug 27, 2020 3:38 pm
-
-
- 0 Replies
- 19670 Views
-
Last post by dd716ted
Mon Jul 09, 2018 6:21 pm
-
- 2 Replies
- 8329 Views
-
Last post by jben04564
Tue May 07, 2019 3:47 pm
-
-
Intertherm M1MB070 Changing Filter
by adwyer53 » Wed Nov 13, 2019 10:22 am » in Nordyne Service & Repair - 0 Replies
- 25620 Views
-
Last post by adwyer53
Wed Nov 13, 2019 10:22 am
-