Miller/ Nordyne E1EH-012HA
When furnace comes on in heat mode it will not shut off or it will take up to 30 min. to shut off. It started with a bad sequencer. Unit would not come on unless you wiggle sequencer. It fell apart so I replaced it with a new one (01-0840). Now it takes forever to cot off. Checked power on sequencer, get 24.77volts when T stat calls for heat and when T stat is satisfied you lose the 24 volts but sequencer stays in so furnace does not shut off. Even tried unpluging harness that carries power to the sequencer to make sure my meter was not missing anything, furnace still kept running. Tried another new sequencer Q103 to make sure I did not get a bad one. A/C works fine. This is an electric furnace. Tested alot of things everything looks good just does not want to shut off! Any ideas!!
Hi,
Make sure none of the coils have fallen down and touching the frame.
IF all is ok and with new sequencer, then make sure all wires are connected in right places.
If so, then may need to call an hvac tech to diagnose the problem, could be a short which is a fire hazard.
Thanks,
Robert
Make sure none of the coils have fallen down and touching the frame.
IF all is ok and with new sequencer, then make sure all wires are connected in right places.
If so, then may need to call an hvac tech to diagnose the problem, could be a short which is a fire hazard.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 25097 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:35 am
-
-
Nordyne Mod. E1EH-015HA split unit/eliminate cooling?
by carolina jim » Thu Oct 24, 2019 8:33 am » in Nordyne Service & Repair - 0 Replies
- 38764 Views
-
Last post by carolina jim
Thu Oct 24, 2019 8:33 am
-
-
-
have intertherm heat pump with a 913421 control box tying to a miller 841 thermo stat ,
by hillcat01 » Mon Oct 21, 2019 7:28 pm » in Nordyne Service & Repair - 0 Replies
- 85648 Views
-
Last post by hillcat01
Mon Oct 21, 2019 7:28 pm
-
-
-
I need wiring assistance for a miller furnace serial number A0981-0685
by Timodell » Wed Nov 20, 2019 10:40 pm » in Nordyne Service & Repair - 0 Replies
- 64688 Views
-
Last post by Timodell
Wed Nov 20, 2019 10:40 pm
-
-
-
Fluctuating flue draft Miller CMF2 80 PO CONV
by ctwap2783 » Sat Feb 22, 2020 9:36 pm » in Nordyne Service & Repair - 0 Replies
- 121497 Views
-
Last post by ctwap2783
Sat Feb 22, 2020 9:36 pm
-