Intertherm defrost problem
I have an Intertherm T3QC-030k series that has been frosting up. Nothing too deep but it isn't going into defrost mode. I had the unit serviced this summer and the technician filled it up with refrigerant. I opened the shroud and looked at the board and can see the 30 60 and 90 pins on the board as well as the jumper on the black wire which is attached just above those three sets of pins. That black wire is on pins ABC TBT. Should it be on one of those sets of pins instead?
Hi,
The black wire should be on either the 30, 60 or 90 pin. That is time between defrost cycles.
Thanks,
Robert
The black wire should be on either the 30, 60 or 90 pin. That is time between defrost cycles.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
intertherm standing pilot propane burner Heat Rise of 38°F spread.
by justplumducky » Fri Aug 25, 2017 10:06 am » in Nordyne Service & Repair - 0 Replies
- 48641 Views
-
Last post by justplumducky
Fri Aug 25, 2017 10:06 am
-
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 67623 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 107892 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-
-
- 0 Replies
- 72787 Views
-
Last post by newguy47
Thu Aug 16, 2018 8:21 pm
-
-
heater blower intertherm feh-015ha-03
by newguy47 » Wed Oct 24, 2018 8:04 am » in Nordyne Service & Repair - 0 Replies
- 79186 Views
-
Last post by newguy47
Wed Oct 24, 2018 8:04 am
-