M1MA070A AW flame going out
Unit runs about 30 secs and flame goes out. Runs a couple of minute and tries again with same result. After a few tries furnace shuts down with failed ignition code. I replaced the igniter/ flame sensor but issue remains. Any thoughts on my next avenue to try? Need to fix soon as it is -25c here.
I am not the sharpest on heating units, But if you have a thermo coupler on the unit I would look at that, they are cheap and when they go bad have the same results.
Greg
Greg
"If I can't fix it, I can screw it up so bad no one else can either."
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 23285 Views
-
Last post by Greg
Tue Sep 05, 2017 6:38 pm
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 48777 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 116140 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-
-
-
Concrete foundation to keep mice out
by Asherjv15 » Thu Jan 02, 2020 5:00 pm » in Mobile Home Repair - 4 Replies
- 36942 Views
-
Last post by mdnagel
Wed Apr 22, 2020 1:14 pm
-
-
-
A message to the MH builders out there
by Mark440 » Sat Oct 10, 2020 1:37 pm » in Mobile Home Repair - 3 Replies
- 42768 Views
-
Last post by Mark440
Sat Oct 10, 2020 7:31 pm
-