Questions about repairs and parts for other brands of furnaces and air conditioners. Please note that our speciality is Coleman and Nordyne products, so our knowledge of other brands may be limited.
Moderators: ponch37300, Mark, flcruising, Greg
I have a blower motor that when its running begins to squeak at times like maybe a bearing is going out. This noise has been happening and going away for several years but now its getting worse. Are replacement motors available for these units any where, or replacement furnaces maybe? I'm sure Duo-Therm (made by Motor Wheel Corp. Lagrange, Indiana) is not in business now.
Any suggestions will be appreciated. Its still in the low 40's at night here.
I was able to disassemble the motor which was clogged up with much dust and lint after 28 years of running without a filter and never having the bushings oiled after 38 years. I cleaned everything else and oiled the bushings, put it all back together and its working great, no more noise. I need a filter set up on the door, with the wire clips to hold it in so this doesn't happen again. If I have too I may tape the filter material or make some clips out of wire.
Any suggestions will still be appreciated.
Second follow up:
For the filter I'm going to try a cut to size 1/4" foam washable filter (as the original was) and hold it in place with either several magnets or a spring loaded loop of braided wire around the existing spot welded brackets on the back of the door.
Third follow up: Update 4/14/12: I made a grille to replace the missing filter clips out of re-mesh like used in concrete reinforcement to hold the filter on to the furnace door. I used a bolt cutter to cut the grille out of the very inexpensive re-mesh.I used a washable cut to fit filter along with the re-mesh grille both available at the large hardware stores, works great.
- Posts: 1
- Joined: Wed Dec 21, 2011 12:41 am
Return to Service & Repair of Other Brands
Who is online
Users browsing this forum: No registered users and 1 guest