Old mobile home electrical
Moderators: Greg, Mark, mhrAJ333, JD
Anyways the short has disappeared so I'm hoping it was some kitchen appliances left from previous owner(she passed away) and they've since been removed. But I'm more concerned that theres possibly a screw that nicked or penetrated the electrical lines that will raise problems in the future. I can't see any realistic way to remove this metal band without destroying it. I also do not know of any way to test the lines if there is no short currently.
You do not have the required permissions to view the files attached to this post.
Please do yourself a favor and replace the wiring. Shorts or possible shorts are nothing to mess with. The last thing we want to hear about hear about is a home destroyed by an Electrical fire and you already have the warning signs.
At the very least have it checked by an Electrician.
Greg
At the very least have it checked by an Electrician.
Greg
"If I can't fix it, I can screw it up so bad no one else can either."
Ya I pulled a "cover" further back on this same perimeter band and they indeed ran electrical through this area the length of the home. I'm trying to figure out the best way to go about accessing it without making alot of damage just before winter. It's basically a Z channel type metal but it's pretty secure and doesn't want to budge. I can cut along the bottom but then I risk blowing snow getting up into the walls. There's screw holes from the previous owner up and down this whole piece where they previously attached the skirting. I can't believe that even in the 60's this was allowed
Many ran under the siding about a foot up. If the siding is screwed on you can open that up without too much work. You could run conduit under the home behind the skirting also.
Greg
Greg
"If I can't fix it, I can screw it up so bad no one else can either."
-
- Posts: 342
- Joined: Fri Apr 06, 2007 9:14 am
- Location: Delaware
- Contact:
I would disconnect the wire, pull it out of the perimeter band and put some 3/4" grey conduit over the wire if it is a sigle wire, reconnect the wire then just anchor the conduit to the bottom of the home near the edge were the belly wrap is close to the floor joist. Where the boxes are use the grey boxes made for the conduit. There should be no metal boxes under there, they are gradually going to rust. That yellow wire is 12 guage (up to 20amp) wire.
If you need flexable conduit then use 3/4" Liguidtight.
Conduit- https://www.lowes.com/pd/JM-Eagle-Non-M ... in/3129571
Ron
If you need flexable conduit then use 3/4" Liguidtight.
Conduit- https://www.lowes.com/pd/JM-Eagle-Non-M ... in/3129571
Ron
-
- Posts: 22
- Joined: Mon Oct 17, 2016 4:38 pm
I had a similar issue in our 1960s/early 70s mobile home. The wires in our place run up the wall, into the ceiling, and back down. We have a basement so i have better access to where I assume the main came in and ran to the original lug fuse box.
Which wires are shorting together on which circuit? By that I mean is there continuity between hot and ground or? Blowing fuses/breakers?
When I moved in to our place I was surprised it had not burnt down. The previous owner attempted to change light fixtures with little knowledge of electrical, which 90% of them were wired in a switch loop. It appears he was unsuccessful and left the fixtures removed after most likely blowing fuses. The main lug box had fire and smoke damage around it plus 30 amp fuses on all circuits. I put in a breaker panel and rewired most of the home.
If the original outlets are still in place I would replace these immediately. Nearly all of the original outlets had arced. Some had very clear smoke damage. If you have a short from hot to neutral, check the outlets. Or perhaps a mess of wires pulled apart in a metal outlet box or junction box. The old outlets tend to crack apart internally.
I had 3 cheesy mobile home kitchen chandaliers that had melted wires and a bathroom wall fan near the floor that had loose wires and started arcing and shooting sparks.
If needed, I can share how the wiring in our place was routed, assuming it was in a similar fashion.
Which wires are shorting together on which circuit? By that I mean is there continuity between hot and ground or? Blowing fuses/breakers?
When I moved in to our place I was surprised it had not burnt down. The previous owner attempted to change light fixtures with little knowledge of electrical, which 90% of them were wired in a switch loop. It appears he was unsuccessful and left the fixtures removed after most likely blowing fuses. The main lug box had fire and smoke damage around it plus 30 amp fuses on all circuits. I put in a breaker panel and rewired most of the home.
If the original outlets are still in place I would replace these immediately. Nearly all of the original outlets had arced. Some had very clear smoke damage. If you have a short from hot to neutral, check the outlets. Or perhaps a mess of wires pulled apart in a metal outlet box or junction box. The old outlets tend to crack apart internally.
I had 3 cheesy mobile home kitchen chandaliers that had melted wires and a bathroom wall fan near the floor that had loose wires and started arcing and shooting sparks.
If needed, I can share how the wiring in our place was routed, assuming it was in a similar fashion.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Are low taxes worth investing into a old mobile home to make it more energy efficient?
by spazatac » Sun Jun 30, 2019 11:30 am » in Off Topic Discussions - 2 Replies
- 32000 Views
-
Last post by spazatac
Sat Jul 06, 2019 6:47 pm
-
-
- 1 Replies
- 23863 Views
-
Last post by Greg
Sat Jul 29, 2017 7:14 pm
-
-
Best electrical outlets to use as replacements
by nestsman » Mon Jan 15, 2018 6:45 pm » in Mobile Home Repair - 2 Replies
- 35588 Views
-
Last post by JaniceGore
Sat Mar 03, 2018 4:02 am
-
-
-
Electrical outlets that are linked to a light switch
by nestsman » Sat Mar 03, 2018 6:32 pm » in Mobile Home Repair - 4 Replies
- 28189 Views
-
Last post by Greg
Mon Mar 05, 2018 6:04 pm
-
-
- 4 Replies
- 31686 Views
-
Last post by Greg
Mon Apr 16, 2018 4:20 pm