Quick question:
Is is acceptable to "cut" (professionally at machine shop), a Nordyne telescoping roof jack? The one that was supplied with the furnace is way to long even in the fully closed position. (Cannot exchange...too much time has elapsed). If cut cleanly and evenly at the furnace side, it seems like it would be fine. Any thoughts?
Nordyne 903666A 51" -95" ( I need less than 51")
Furnace M1MC 070A
Thanks!
Todd
Nordyne Telescoping Roof Jack
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Questions about steel roof options for arched roof
by Reezer76 » Thu Sep 14, 2017 9:41 pm » in Mobile Home Repair - 2 Replies
- 63048 Views
-
Last post by JD
Sun Sep 17, 2017 4:31 pm
-
-
- 5 Replies
- 101851 Views
-
Last post by JenniferK
Wed Nov 22, 2017 12:52 am
-
- 2 Replies
- 64297 Views
-
Last post by JenniferK
Fri Nov 24, 2017 2:02 am
-
-
Roof replacement and roof over project - combined
by Joemontana » Mon May 04, 2020 9:02 pm » in Mobile Home Repair - 1 Replies
- 65291 Views
-
Last post by Greg
Tue May 05, 2020 5:06 pm
-
-
-
Metal roof over, SW with a peaked metal roof
by Hwystar73 » Thu Dec 17, 2020 9:25 pm » in Mobile Home Repair - 3 Replies
- 91341 Views
-
Last post by Hwystar73
Sun Jan 03, 2021 6:20 pm
-