I have a Miller Model CMF80-PG propane furnace PGB-1-01
The furnace starts fine and heats up properly but cycles on and off
after about 4 min. until room temp is met then turns off as it's
suppose to. The furnace was installed in 2002.I was wondering if
this is normal or is it suppose to run until room temp is met? I just
bought the property so not sure how the furnace ran before.
Any ideas? Gas and blower stop then furnace reignites and blower comes back on about every 4 min or so.
Miller Model CMF80-PG propane furnace problem ?
Hi,
That's not normal and due to some safety problems that can cause this, it should be inspected by a HVAC Tech.
Could be overheating and cutting out on a Limit. for example.
Thanks for inquiring,
Robert
That's not normal and due to some safety problems that can cause this, it should be inspected by a HVAC Tech.
Could be overheating and cutting out on a Limit. for example.
Thanks for inquiring,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Where to place propane wall heaters?
by nestsman » Wed Jun 28, 2017 2:18 pm » in All Other HVAC Questions - 5 Replies
- 53380 Views
-
Last post by suzy_dickson
Fri Jul 05, 2019 1:24 am
-
-
-
intertherm standing pilot propane burner Heat Rise of 38°F spread.
by justplumducky » Fri Aug 25, 2017 10:06 am » in Nordyne Service & Repair - 0 Replies
- 49649 Views
-
Last post by justplumducky
Fri Aug 25, 2017 10:06 am
-
-
-
Propane wall heater flickers badly
by nestsman » Tue Nov 28, 2017 1:23 pm » in Service & Repair of Other Brands - 2 Replies
- 30653 Views
-
Last post by suzy_dickson
Fri Jul 05, 2019 12:54 am
-
-
- 0 Replies
- 39978 Views
-
Last post by MobileMike
Sat Oct 26, 2019 12:57 am
-
-
I need wiring assistance for a miller furnace serial number A0981-0685
by Timodell » Wed Nov 20, 2019 10:40 pm » in Nordyne Service & Repair - 0 Replies
- 61294 Views
-
Last post by Timodell
Wed Nov 20, 2019 10:40 pm
-