MMHB-07ABHR-06 intermitent problems
This furnace will run for several weeks then lock out and give the 3 flash code. I power off and reset and it works fine for several more weeks. Today I have noticed it will call for heat and the burner fires. It stays on about a minute and goes out and then 10 or so seconds later will fire up again. The blower does not operate till after the second series of burner. Is this normal or am I starting to have issues. It is a 1996 furnace. 1 draft motor and 2 igniters is all the trouble in 12yrs.
Hi,
Three flashes is a failed ignition attempt, gas valve error or false flame sensed during warm up period.
You should never reset and continue using without finding reason for lock out and resolving that issue.
It would be best to have an hvac tech come and diagnose which problem is causing this and repairing correctly.
Thanks,
Robert
Three flashes is a failed ignition attempt, gas valve error or false flame sensed during warm up period.
You should never reset and continue using without finding reason for lock out and resolving that issue.
It would be best to have an hvac tech come and diagnose which problem is causing this and repairing correctly.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
- 0 Replies
- 44303 Views
-
Last post by chrismc_us
Mon Dec 23, 2019 9:00 am
-
-
2-combo single pole lightswitch problems
by hstassen » Mon Jan 06, 2020 9:41 pm » in Mobile Home Repair - 2 Replies
- 12968 Views
-
Last post by Greg
Tue Jan 07, 2020 6:12 pm
-