I was having issues with my furnace not operating properly. The heating element would cycle on and off every 30 seconds or so and wouldn't turn off when the room got to temperature. It got to the point where the only way I could control the furnace was to turn the breaker on and off at the breaker box.
In reading this forum, it appeared the problem was the sequencer. I just installed my new sequencer 621451 and now the furnace will shut off when the room gets to temperature.
However, now the heating element remains on. I've removed the blower and checked the coils. They are still mounted in factory position, with nothing touching them.
Any suggestions?
Mike in Urbana, OH
Nordyne model FEH-012HA
Hi Mike,
You would have to test each element to determine which one(s) were staying on first.
Then, trace test the circuit back from the element through sequencer and on to find where the source of power was coming from.
Thanks,
Robert
You would have to test each element to determine which one(s) were staying on first.
Then, trace test the circuit back from the element through sequencer and on to find where the source of power was coming from.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 20527 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:35 am
-
-
Intertherm/Nordyne feh-015ha furnace issues blower not working, unit will only turn off at breaker box
by onmypath78 » Sat Mar 16, 2019 12:11 pm » in Nordyne Service & Repair - 0 Replies
- 150345 Views
-
Last post by onmypath78
Sat Mar 16, 2019 12:11 pm
-
-
- 0 Replies
- 71193 Views
-
Last post by newguy47
Thu Aug 16, 2018 8:21 pm
-
-
heater blower intertherm feh-015ha-03
by newguy47 » Wed Oct 24, 2018 8:04 am » in Nordyne Service & Repair - 0 Replies
- 77568 Views
-
Last post by newguy47
Wed Oct 24, 2018 8:04 am
-
-
-
intertherm feh-015ha-04 Noisy Blower
by kjaxes99 » Sat Oct 24, 2020 4:45 am » in Nordyne Service & Repair - 0 Replies
- 130196 Views
-
Last post by kjaxes99
Sat Oct 24, 2020 4:45 am
-