Page 1 of 1
New M3RL
Posted: Fri Jun 26, 2009 6:33 pm
by bhough
I will be ordering a new M3RL natural gas furnace next week to replace the exsisting CMF oil. Does M3RL-080A-BW
sound ok? Do you have to mention natural gas to get that type? Or is it the default? I will be getting a concentric vent term. kit, part # 904176 (3"). I hope the ordering numbers are correct.
Brian
RE: New M3RL
Posted: Sat Jun 27, 2009 1:29 am
by Robert
Hi Brian,
Should be ok, but cannot say for sure without being there. Yes, it will be set for natural gas.
Thanks,
Robert
Re: RE: New M3RL
Posted: Sat Jun 27, 2009 7:06 am
by bhough
It has been a good project, new gas line/meter from main, new piping through the attic, new gas (tankless) Rinnai water heater, a new Rinnai wall heater, & the furnace replacement. I just hope the cost of gas doesn't skyrocket. Thanks for all of your advice.
Brian
It
Robert wrote:Hi Brian,
Should be ok, but cannot say for sure without being there. Yes, it will be set for natural gas.
Thanks,
Robert
RE: New M3RL
Posted: Sat Jun 27, 2009 1:30 pm
by Robert
Hi Brian,
You're very welcome, happy to help. With Obama's Cap & Trade deal, gas will double at the minimal, so hold on tight.
