Nordine (Miller) Oil Furnace cycles MANY times on cool down
I have a newer Miller Oil Furnace (now Nordine), Model # CMF2-80(PO), S# cma06/20058. It works great... once the burner shuts off, the fan continues to run until it reaches the low limit setpoint - but then it will cycle the circulating fan on and off between 9 to 12 times before it shuts down completely... takes about 1.5 - 2 minutes of this annoying cycling to turn off completely. The blue limit (electronic) setpoint label says F115-20F (part # 626552). I'll assume it takes the heat exchanger temperature down to 115F, with a 5 degree variance? Is this a flaw in the Miller design or do I have a bad limit switch or ? Would a different switch with a greater variance stop this problem? Walter Cordes, Cedarville Michigan.
Hi Walter,
That is not a limit, it is the fan switch.
It kicks the blower in at 115* and then after burner shut down, keeps blower running until chamber cools to 95*.
This could be a bad switch or a problem in heat exchanger not allowing heat to dissipate or air getting across the switch for some reason.
Due to possibility of a safety issue, would be best to have an hvac tech check it out.
Miller is made/owned by Nordyne.
Thanks,
Robert
That is not a limit, it is the fan switch.
It kicks the blower in at 115* and then after burner shut down, keeps blower running until chamber cools to 95*.
This could be a bad switch or a problem in heat exchanger not allowing heat to dissipate or air getting across the switch for some reason.
Due to possibility of a safety issue, would be best to have an hvac tech check it out.
Miller is made/owned by Nordyne.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Nordyne M1MB clicks 4 times when starting
by olsonlaaa » Thu Aug 24, 2017 10:54 am » in Nordyne Service & Repair - 0 Replies
- 46250 Views
-
Last post by olsonlaaa
Thu Aug 24, 2017 10:54 am
-
-
- 0 Replies
- 29628 Views
-
Last post by plumducky
Tue Dec 10, 2019 3:08 pm
-
-
swamp cooler in hallway, how to get the rest of my mobile home cool?
by grateful » Mon May 25, 2020 7:30 pm » in All Other HVAC Questions - 0 Replies
- 100003 Views
-
Last post by grateful
Mon May 25, 2020 7:30 pm
-
-
-
I need wiring assistance for a miller furnace serial number A0981-0685
by Timodell » Wed Nov 20, 2019 10:40 pm » in Nordyne Service & Repair - 0 Replies
- 64071 Views
-
Last post by Timodell
Wed Nov 20, 2019 10:40 pm
-
-
- 0 Replies
- 24874 Views
-
Last post by Tonystark
Fri Dec 07, 2018 12:30 pm