Page 1 of 1
e2eb-015 a/c blower fan not working
Posted: Fri Jun 04, 2010 1:28 pm
by dreece1952
Fan blower was cutting off/set on "auto" on but would work when set "on". The other night we had a hot smell and haven't run it since.
Sequencer was replaced last fall.
Any suggestions?
Thanks
Re: e2eb-015 a/c blower fan not working
Posted: Fri Jun 04, 2010 4:28 pm
by Robert
Was it being used for a/c, heat or fan only at time of heat smell and cutting off ?
Thanks,
Robert
Re: e2eb-015 a/c blower fan not working
Posted: Mon Jun 07, 2010 7:15 am
by dreece1952
set on air. husband says when fan first cut on would go up through speeds then cut back to slow before cutting off.
Re: e2eb-015 a/c blower fan not working
Posted: Mon Jun 07, 2010 1:16 pm
by Robert
Hi,
That sounds like a possible wiring short in the wiring itself or the motor. In a/c mode, motor should come on in high speed and remain there.
Look at all wiring and components and connector plugs.
Try to find where hot smell is from. With motor going through speeds, IF it is then that could burn the motor up.
Check the molex plug closely and the wires.
Thanks,
Robert