Recently, my Furnace has been blowing cold air with it set on heat setting. I've tested the 2 elements and I get resistance on both of them and they aren't grounded out. I've checked the wires and contacts and all seem good. Also, I've felt heat a couple of times from the elements during testing out of about 10 times I've turned it on. I'm starting to suspect that the sequencer is bad.
Trouble is, I can't find the exact part that goes in it. It's a 2-pole sequencer and the on/off times for it are 1-24 / 45-75 and these times seem to be hard to find in a sequencer. I read other posts on here and the "01-0840 Sequencer " on your guy's online store seems to be recommended but what are the on/off times for this sequencer?
Thanks,
E1EH-012 may need sequencer.
Hi,
1 - 20 and 40 - 110 are the times. 01-0840 is the sequencer recommended by the furnace manufacturer.
Those times have a window and do change as new replacements are designed.
Sequencer # 01 - 0840 can be seen and ordered from here by paging down:
http://www.aberdeenhomerepair.com/store ... 8621696%29
Thanks,
Robert
1 - 20 and 40 - 110 are the times. 01-0840 is the sequencer recommended by the furnace manufacturer.
Those times have a window and do change as new replacements are designed.
Sequencer # 01 - 0840 can be seen and ordered from here by paging down:
http://www.aberdeenhomerepair.com/store ... 8621696%29
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Posts: 3
- Joined: Fri Oct 29, 2010 5:09 pm
Thanks for clearing that up, Robert.
Just now ordered one. Hope it's fixed after this.
Just now ordered one. Hope it's fixed after this.
-
- Posts: 3
- Joined: Fri Oct 29, 2010 5:09 pm
I got the part in the other day and replaced it. My furnace is functioning again. Thanks again for your time, Robert.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 26002 Views
-
Last post by andyodham
Mon Jan 22, 2018 8:27 pm
-
- 0 Replies
- 32190 Views
-
Last post by Troydean3326
Thu Dec 13, 2018 7:17 pm
-
-
Eb15b sequencer & limit switch testing
by ferret13sj » Tue Jan 25, 2022 1:56 am » in Coleman Service & Repair - 0 Replies
- 116336 Views
-
Last post by ferret13sj
Tue Jan 25, 2022 1:56 am
-
-
- 2 Replies
- 21131 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:35 am
-
-
Nordyne Mod. E1EH-015HA split unit/eliminate cooling?
by carolina jim » Thu Oct 24, 2019 8:33 am » in Nordyne Service & Repair - 0 Replies
- 34362 Views
-
Last post by carolina jim
Thu Oct 24, 2019 8:33 am
-