E1EH-012 may need sequencer.
Posted: Fri Oct 29, 2010 5:23 pm
Recently, my Furnace has been blowing cold air with it set on heat setting. I've tested the 2 elements and I get resistance on both of them and they aren't grounded out. I've checked the wires and contacts and all seem good. Also, I've felt heat a couple of times from the elements during testing out of about 10 times I've turned it on. I'm starting to suspect that the sequencer is bad.
Trouble is, I can't find the exact part that goes in it. It's a 2-pole sequencer and the on/off times for it are 1-24 / 45-75 and these times seem to be hard to find in a sequencer. I read other posts on here and the "01-0840 Sequencer " on your guy's online store seems to be recommended but what are the on/off times for this sequencer?
Thanks,
Trouble is, I can't find the exact part that goes in it. It's a 2-pole sequencer and the on/off times for it are 1-24 / 45-75 and these times seem to be hard to find in a sequencer. I read other posts on here and the "01-0840 Sequencer " on your guy's online store seems to be recommended but what are the on/off times for this sequencer?
Thanks,