Search found 5 matches
- Sat Sep 20, 2014 11:05 pm
- Forum: Nordyne Service & Repair
- Topic: CMF 80 PG ignition sequence question with new 1018
- Replies: 0
- Views: 15302
CMF 80 PG ignition sequence question with new 1018
Nordyne CMF 80 PG Last year I replaced the ignition control module (UT 1018 series). The furness works but the start up sequence is slightly different. I just want to confirm this is normal and the furness is safe. 1* After a call for heat the induced draft motor turns on for a short time, the centr...
- Fri Jan 13, 2012 2:27 pm
- Forum: Nordyne Service & Repair
- Topic: How hot should the furnace be getting?
- Replies: 5
- Views: 11094
Re: How hot should the furnace be getting?
Replaced high limit switch. The funace was purchased last year (blower included) as a hole re-conditiond unit from local service center. I was wondering about that. The blower should move as much heat as the furnace produces. And come to think of it my old furnace did reach the high limit switch reg...
- Sun Dec 25, 2011 2:29 am
- Forum: Nordyne Service & Repair
- Topic: How hot should the furnace be getting?
- Replies: 5
- Views: 11094
How hot should the furnace be getting?
CFM 80 PG conv. Just fixed the problem with the furnace shutting itself (not detecting flame) turned out to be a bad relay in the brain wich I replaced. I am worried now the furnace may be over heating. After comming home and turning up the thermostat from 69 to 71. The air comming out of the vents ...
- Thu Nov 17, 2011 6:26 pm
- Forum: Nordyne Service & Repair
- Topic: CFM 80 PG flame sensor testing
- Replies: 0
- Views: 8109
CFM 80 PG flame sensor testing
CFM 80 pg. I've tracked a problem to what I believe is a faulty flame sensor.(6622500) But on this unit the flame sensor is incorporated in the ignighter. How does this work with just the two wires? Is there a way to test the flame sensor portion or bypass for diagnostic proposes? When the furnace s...
- Sun Feb 27, 2011 6:44 pm
- Forum: Nordyne Service & Repair
- Topic: Induced draft adjustment?
- Replies: 1
- Views: 3574
Induced draft adjustment?
Just installed a Miller cfm 80 pg Propane furnace. Need help adjusting the vent in the induced draft motor. What should the flame look like inside the window? How high should the flame be?