problems with blower motor
model no. EB2OB seems to have dried bearings,Am able to turn fan motor by hand to get started,but after it reaches correct temperature and shuts off it will not start again.Do i have dried up bearings,
Hi,
I am going to move this thread to the HVAC forum. Please read the posting tips on the main page in HVAC. The tech will need further info on your unit.
Thanks,
Yanita
I am going to move this thread to the HVAC forum. Please read the posting tips on the main page in HVAC. The tech will need further info on your unit.
Thanks,
Yanita
The difference between success and failure is who gives up first!
Hi,
First make sure it is getting full 240VAC to the motor leads with call for heat from t-stat. If so:
If you can spin the squirrel cage for several revolutions with out it stopping and it is easy to spin, may be a bad run capacitor.
Since you have to replace the run cap with any motor replacement, replace that and see if it solves it.
If not and it has 240VAC, replace the motor.
You could possibly take to motor shop, but parts and labor charges would make it more feasible to replace motor and have a warranty.
That is if anything could be done for it in first place.
Take care and best wishes,
Robert
First make sure it is getting full 240VAC to the motor leads with call for heat from t-stat. If so:
If you can spin the squirrel cage for several revolutions with out it stopping and it is easy to spin, may be a bad run capacitor.
Since you have to replace the run cap with any motor replacement, replace that and see if it solves it.
If not and it has 240VAC, replace the motor.
You could possibly take to motor shop, but parts and labor charges would make it more feasible to replace motor and have a warranty.
That is if anything could be done for it in first place.
Take care and best wishes,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 60176 Views
-
Last post by jazsimpson
Sat Jul 08, 2017 8:16 am
-
- 0 Replies
- 25686 Views
-
Last post by Tonystark
Fri Dec 07, 2018 12:30 pm
-
- 0 Replies
- 45030 Views
-
Last post by chrismc_us
Mon Dec 23, 2019 9:00 am
-
-
2-combo single pole lightswitch problems
by hstassen » Mon Jan 06, 2020 9:41 pm » in Mobile Home Repair - 2 Replies
- 13487 Views
-
Last post by Greg
Tue Jan 07, 2020 6:12 pm
-
-
-
Need advice on blower
by NorthTexasSafariGuy » Mon Jul 31, 2017 9:18 am » in Coleman Service & Repair - 0 Replies
- 70534 Views
-
Last post by NorthTexasSafariGuy
Mon Jul 31, 2017 9:18 am
-