furnace blowing cold
-
- Posts: 2
- Joined: Wed Mar 04, 2009 7:24 pm
- Location: Tennessee
I have a nordyne furnace #E2EB 010. Due to a recent short in the system. I have replaced the Blower motor, blower relay, and sequencer. Since then it will blow warm air sometimes. Usually it blows normal cool air. Should I have replaced the Limit switch too? Is that the problem? Thanks
-
- Posts: 2
- Joined: Wed Mar 04, 2009 7:24 pm
- Location: Tennessee
All of the wires are new also. Also the outside heat pump is not working. I opened the cover on my thermostat and notice a burn mark on the white wire at the soder point on the top mercury tube with the green tip. The only way i am getting heat is when the bottom mercury tube with orange tip activates im guessing that is the emergency heat. Thanks
-
- Similar Topics
- Replies
- Views
- Last post
-
- 0 Replies
- 102442 Views
-
Last post by caltrop18
Tue Dec 01, 2020 3:05 pm
-
-
Ducts barely blowing - what to check first?
by caligirl » Fri Nov 25, 2022 1:21 pm » in All Other HVAC Questions - 0 Replies
- 112453 Views
-
Last post by caligirl
Fri Nov 25, 2022 1:21 pm
-
-
- 0 Replies
- 33491 Views
-
Last post by Elainesplay
Sat Jul 13, 2019 9:54 am
-
-
DGAT Series furnace air-conditioning issue
by minnie1967 » Thu Jul 13, 2017 9:48 am » in Coleman Service & Repair - 0 Replies
- 61845 Views
-
Last post by minnie1967
Thu Jul 13, 2017 9:48 am
-
-
-
Acceptable HEAT RISE number for this 20-yr. old furnace.
by justplumducky » Tue Aug 29, 2017 5:33 pm » in Nordyne Service & Repair - 0 Replies
- 44299 Views
-
Last post by justplumducky
Tue Aug 29, 2017 5:33 pm
-