Nordyne-Intertherm furnace MMHB-070ABHR-06 not lighting
Hi and Welcome,
I am not able to find a code light manual for your furnace. So i was wondering if you can look and see if anywhere on your furnace or furnace doors that there is a trouble code chart. If not then at what point does your furnace begin to fail. Here is a link on the basic operation of a furnace. This will be helpful in figuring out when your furnace fails to start.
http://www.youtube.com/user/pexring#p/a/u/2/dO5_wuCWFqA
Hope this helps
Bill
I am not able to find a code light manual for your furnace. So i was wondering if you can look and see if anywhere on your furnace or furnace doors that there is a trouble code chart. If not then at what point does your furnace begin to fail. Here is a link on the basic operation of a furnace. This will be helpful in figuring out when your furnace fails to start.
http://www.youtube.com/user/pexring#p/a/u/2/dO5_wuCWFqA
Hope this helps
Bill
Please remember to check and change your filters.
Was this issue resolved? I'm having the same problem with a Nordyne/Intertherm MMHB-070ABHR-06 furnace with a UTC 1018-204 controller. The controller clicks once after about 30 seconds and then repeatedly flashes the diagnostic light two times. I have replaced the ignitor but it's still doing the same thing. Any advice will be appreciated. Thanks!
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Intertherm/Nordyne feh-015ha furnace issues blower not working, unit will only turn off at breaker box
by onmypath78 » Sat Mar 16, 2019 12:11 pm » in Nordyne Service & Repair - 0 Replies
- 167293 Views
-
Last post by onmypath78
Sat Mar 16, 2019 12:11 pm
-
-
-
Kitchen lighting---I want recessed though
by varadarcop » Sat Apr 03, 2021 1:22 am » in Mobile Home Repair - 7 Replies
- 45749 Views
-
Last post by Sulteric
Sun Sep 05, 2021 9:43 pm
-
-
-
Nordyne M1B1 furnace issue - thermostat c wire not hooked up correctly. It's running off atteries instead
by Tallestt » Mon Apr 20, 2020 6:27 am » in Nordyne Service & Repair - 1 Replies
- 43229 Views
-
Last post by taurolyon
Tue Jun 23, 2020 4:02 pm
-
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 74818 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 116358 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-