CFM 80 pg. I've tracked a problem to what I believe is a faulty flame sensor.(6622500) But on this unit the flame sensor is incorporated in the ignighter.
How does this work with just the two wires? Is there a way to test the flame sensor portion or bypass for diagnostic proposes?
When the furnace starts the wires leading to the ignighter read 110vac. The infighter glows, a few seconds latter the furnace ignights and the voltage drops to 0. Then in a few seconds or up to a min the furnace shuts off the gas valve and startes the start up process all over.
CFM 80 PG flame sensor testing
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Eb15b sequencer & limit switch testing
by ferret13sj » Tue Jan 25, 2022 1:56 am » in Coleman Service & Repair - 0 Replies
- 125468 Views
-
Last post by ferret13sj
Tue Jan 25, 2022 1:56 am
-