I made a lift out section for the counter top, it worked out well. The wife wanted a section between the stove and the counter top where the sink is. She needed it removable so she could get to the drawer in that corner.
Here it is without the section:
Here is the section:
Here is the corner:
Here is the counter top from the fridge to the stove and the lift out section I made:
I cut a section of counter top, then, used the aluminum transition pieces I got from Lowe's, and screwed them to the section. The pieces from Lowe's are made to be used between the counter top and stove to eliminate the gap between them. They worked well in this application!
Jerry
Counter Top Lift Out Section
Moderators: Greg, Mark, mhrAJ333, JD
Looks good. In case you didn't already, you may want to put something soft on the bottom side of the Aluminum to prevent scratching the stove & counter. A piece of foam strip insulation should work fine.
Greg
Greg
"If I can't fix it, I can screw it up so bad no one else can either."
Heat resistant stuff, right? Might be better from an auto parts store.
☯JD♫
Today is PERFECT!
All information and advice given is for entertainment and informational purposes only. The person doing the work is solely responsible to insure that their work complies with their local building code and OSHA safety regulations.
Today is PERFECT!
All information and advice given is for entertainment and informational purposes only. The person doing the work is solely responsible to insure that their work complies with their local building code and OSHA safety regulations.
- larryjohnson
- Posts: 1
- Joined: Wed Sep 12, 2012 1:16 am
- Location: 830 S Valleywood Cir, Hixson, TN 37343
Your granite counter tops looks amazing. In order to avoid it from scratching cover the counter tops with some of the materials like rubber sheet, cloth, plastic or wooden board. You also get some spray available in market to remove stain or scratches from the counter tops.
Last edited by larryjohnson on Thu Sep 13, 2012 10:56 pm, edited 1 time in total.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 48948 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-
-
-
Replacing Plastic Counter Wall Edging
by karlaneese » Mon May 28, 2018 9:16 am » in Mobile Home Repair - 1 Replies
- 3050 Views
-
Last post by Greg
Mon May 28, 2018 12:31 pm
-
-
-
What Is This "Feature" At the Top of the Exterior Walls
by MandMLawson » Mon Aug 26, 2019 9:03 pm » in Off Topic Discussions - 1 Replies
- 20258 Views
-
Last post by Greg
Tue Aug 27, 2019 7:08 pm
-
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 116352 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-
-
-
Concrete foundation to keep mice out
by Asherjv15 » Thu Jan 02, 2020 5:00 pm » in Mobile Home Repair - 4 Replies
- 37140 Views
-
Last post by mdnagel
Wed Apr 22, 2020 1:14 pm
-