I had a worker cutting out my particleboard floors. Because mobile homes from the 70's were put together in wacky ways, he accidentally cut right through a galvanized water line and we had to replace the pipe.
The pipe wasn't even at the bottom area of the joist. It was actually right under the sub floor at the very top!
Based on what I have seen in my floors in the past, I told him, this was how they originally built it.
But he thinks that someone had actually opened this floor up before and didn't know what they were doing when they added this pipe which runs from the main inlet on one side of home to the water heater on the opposite side.
Now we have a friendly argument as to who is correct.
Can anyone confirm that it's not uncommon to find water lines right under the sub floor (and in some cases running across the top of air ducts) in old mobile homes.
Water Pipes located directly under sub-floor normal ???
Moderators: Greg, Mark, mhrAJ333, JD
In 70's and earlier mobile homes, it is common to find plumbing, usually polybutylene PB pipe right against the bottom of the particle board subfloor. I have not seen galvanized pipe factory installed, so this may well be a repair. But it makes sense that the person doing the repair would mimic the pipe he is replacing. Be careful with saws on these older floors. You could just as easily find hot romex.
I set my saw just a hair under 5/8" when I cut. The floor will bust out easy from there. Against walls or places where you need to use a sawzall, I will carefully bust out a 6"x6" hole, just using the nailing head of my hammer, then feel around the cut area to be sure there are no pipes or wires. If you do this every time, every single time, after enough years, it will still trick you.
I set my saw just a hair under 5/8" when I cut. The floor will bust out easy from there. Against walls or places where you need to use a sawzall, I will carefully bust out a 6"x6" hole, just using the nailing head of my hammer, then feel around the cut area to be sure there are no pipes or wires. If you do this every time, every single time, after enough years, it will still trick you.
☯JD♫
Today is PERFECT!
All information and advice given is for entertainment and informational purposes only. The person doing the work is solely responsible to insure that their work complies with their local building code and OSHA safety regulations.
Today is PERFECT!
All information and advice given is for entertainment and informational purposes only. The person doing the work is solely responsible to insure that their work complies with their local building code and OSHA safety regulations.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 26101 Views
-
Last post by Greg
Thu Oct 24, 2019 6:50 pm
-
-
Sagging floor under toilet, need help with size of shutoff fittings
by ferret13sj » Thu Nov 17, 2022 9:37 pm » in Mobile Home Repair - 4 Replies
- 63190 Views
-
Last post by yakima4$
Thu Dec 01, 2022 11:16 pm
-
-
-
I need input on best way to hang new copper or pex pipes from underside mobilehome without opening up belly board
by waitingtohear » Mon Jun 11, 2018 12:21 am » in Mobile Home Repair - 7 Replies
- 89466 Views
-
Last post by waitingtohear
Mon Jul 02, 2018 5:39 pm
-
-
- 2 Replies
- 28272 Views
-
Last post by mdnagel
Tue Jun 04, 2019 6:36 pm
-
-
Water Accumulating Under Home
by rockncountry101 » Tue May 04, 2021 12:55 pm » in Mobile Home Repair - 0 Replies
- 105999 Views
-
Last post by rockncountry101
Tue May 04, 2021 12:55 pm
-