Robert or Mark!
The specs for the motor are as follows:
KA55HXSMW-2346 HP 1/3 Volt 115 HZ60 Amp 5.0 PH 1 RPM 1075/3spd
Didn't see one in the motor column listing where you purchase furnace part's.
Did see one that had the white plug connector that looks like mine that goes into the control relay box.
I want to purchase the generic brand like the one I purchased some years back that cost me $99.00.
Making a strange noise & don't want it to go out getting so close to hot weather.
My wife has Fibro & is a diebetic & can't afford to be stuck in this house in hot conditions.
The one thats in it now is the one my stepson installed for me & is a 3/4 hp.
It is too much hp & rpm for my Intertherm unit.
It merely blows too much air out in the winter time using the gas unit.
I don't use the furnace anymore because of that.
We use 4 electric heaters.
Two are radiant oil type & the other two are coiled filament type.
Eating us up on our electric bill.
Now its getting summer time so not too big a thing.
Time to get a new one again.
Thank's for helping me get the correct one
Mark or Robert!
Brent
MGH-055-ABWN-06 central a/c gas furnace motor needed
I am a certified ford diesel tech, "Retired Now" Ford Parts Department counter man, computer consultant, repairman & programmer
Thank's Greg!
Will do!
Will do!
I am a certified ford diesel tech, "Retired Now" Ford Parts Department counter man, computer consultant, repairman & programmer
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Model DGAA070BDTA venting kit needed.
by spazatac » Fri May 24, 2024 11:21 am » in Coleman Service & Repair - 2 Replies
- 302 Views
-
Last post by spazatac
Mon Jun 10, 2024 3:11 pm
-
-
- 2 Replies
- 60176 Views
-
Last post by jazsimpson
Sat Jul 08, 2017 8:16 am
-
- 0 Replies
- 25686 Views
-
Last post by Tonystark
Fri Dec 07, 2018 12:30 pm
-
-
I am thinking of switching to a gas water heater
by deryk the gypsy » Sat Jul 22, 2017 7:16 am » in Mobile Home Repair - 2 Replies
- 39017 Views
-
Last post by Greg
Sat Jul 22, 2017 12:26 pm
-
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 48955 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-